10 Miter Saw Safety Tips

There are safety tips while working with power tool, you need to keep in mind for safety measure.

• Use a mobile miter saw stand
• Install a laser
• Make repetitive cuts using stop blocks
• Cut wider boards
• Let the blade reach maximum speed
• Upgrade your saw blade
• Construct a miter saw jig to hold moldings
• Add an auxiliary fence for small piece cutting
• Draw signs for danger on the fence
• Get a double tilt saw

At the workshop you can easily place the miter saw on the workbench but on the job site you will need to switch the position so for this miter saw stand will be a blessing.

Laser shows light towards the work piece blade has to cut. It gives a great vision and helps you cut thoroughly with great speed. As you will need not to put the saw down whether it is on the mark or not. The laser will help you to cut the work piece on the marked line.

You can simply set the desired measurement on the miter saw and clamp the stop block on the miter saw stand to the length that has to be cut repeatedly. This will save lot of time.

To increase the speed with a non-sliding miter saw then place the wide board under the board you want to cut then make the cut. Or cut the first side of the board, flip it and then cut the other side.

Just by switching it on, the speed of the miter saw take seconds to reach the maximum speed. So just wait for 3 to 5 seconds before cutting the work piece as the speed will get faster and job will be done smoothly.

All the cutting depends on the blade, invest good amount in blade to get quality based results.

By constructing miter saw jig it will become easier to cut crown and cove mouldings.

Small cutting from a long one is risky, an auxiliary fence will prevent any sort of injury or incident to take place.

To keep reminded not to place your hand on the boundary unconsciously, draw lines with a red marker on the to stay at a safe side.

It is better to get a double tilt saw that offers you bevel cut and simple crosscut at the same time than to have a single tilt saw.